Clean Crawl Space Falling Water TN

The crawl space has an integral role towards a home’s overall value as well as the living space above. Most homeowners in Falling Water Chattanooga  don’t think twice about their crawl space unless they have to make repairs to plumbing, heating ducts or house wiring. While often thought of as no more than a storage area, it also has a tremendous impact on the overall indoor air quality of the entire home.

crawlspacerepair com

The Best Basement Waterproofing In Falling Water TN

By default, the air quality of a crawl space is typically poor. Mold, mildew, radon gas and poor energy efficiency all create several problems. The air that circulates within it eventually makes its way up through the living space. Scientific studies show that up to 50% of living space air originates from the lowest level of the home. With homeowners more concerned about their home’s indoor air quality, the encapsulating of crawl spaces has become a popular solution for such problems.

A damp crawl space creates a safe harbor for harmful molds, in addition to dust mites, termites and other bugs that can infest the home. The presence of excessive moisture will also create a serious problem with the probability for the wooden structure of a home to deteriorate. Crawl space vents pose a further problem. While believed to be a solution to moisture problems, they, unfortunately, make the problem worse. As it turns out, the vents allow cold air and moisture in, which rises into the living area and therefore decreases the heating efficiency of the entire home.

Another all-too-common problem associated with crawl spaces is radon gas. Though it cannot be seen, smelled or tasted, radon is a radioactive gas that can contribute to poor health, including cancer. Radon gas makes its way through the earth, into the crawl space and the home’s living space. According to the U.S.E.P.A., radon gas is the number one leading cause of lung cancer in non-smokers.

Ignoring these various conditions is not recommended for both long-term health and energy usage. Fully encapsulating a crawl space – by both sealing and insulating – is a fully efficient measure in addressing such problems. It makes sense to maintain and improve the lower level area in order to maximize healthy living conditions and home resale value.

While there are several systems for encapsulating, a zero perm liner system that also insulates and reflects heat provides the most benefits. With a proper floor and wall liner, the area will not only be well insulated but will seal out moisture, bug infestation, and radon gas. Other components to look for in a system include a radon gas-dispersing drain fabric, a radon gas ventilation pipe, and a ceiling heat shield.

A complete system with all of the above components will allow any soil gasses – including radon gas – that naturally occur under the liner system, to wick through the drain fabric and escape out through the ventilation pipe. While improved indoor air quality is the primary benefit of a sealed and insulated crawl space, the homeowner will also appreciate a bright, clean, and dry storage area; the ridding of musty smells; less energy usage; and tax credits. Contractors encapsulating crawl spaces will have more to offer to their clients when they can assure the peace of mind with improved indoor air quality.

dry out crawl space

Improving a Home's Indoor Air Quality by Crawl Space Encapsulation

In recent years, the idea of indoor air quality control has become a bigger concern to the basement waterproofing industry. When I began working with the industry over 20 years ago, the idea of basement waterproofing was exclusive to the controlling of and prevention of water seepage and flooding. With homeowners becoming more aware of radon gas infiltration, moisture and mildew, and other soil gases, waterproofers have the perfect opportunity to better serve their customers by addressing such needs.

Musty smells, moisture and radon gas - all common problems in a basement and/or crawl space, are solvable by enacting some of the most basic waterproofing techniques. Improving indoor air quality, beginning from the basement and/or crawl space will impact the air quality of the entire home. Over 50 percent of the air that circulates through the home's living space originates from the basement and or crawl space. When the air quality of the basement or crawl space is poor, chances are, the entire home's air quality is poor or soon will be.

One of the first measures a contractor can do to address such concerns is by applying a sodium based silicate spray onto the basement's walls and floors. Such a spray typically reacts with the concrete's free lime, resulting in the formation of an expanded crystalline structure beneath the surface. The application of a deep-penetrating concrete sealer stops water vapor and radon gas from permeating the porous surfaces. This allows the concrete to become dense, increasing its resistance to various vapors and gases. Such sealants usually can be applied with a low-pressure hand sprayer.

When applying the right sodium based silicate spray, some of the additional advantages may include the reduction of spalling from freeze and thaw cycles; improving a concrete structure's resistance to most soils, acids, oils and salts; and protecting against efflorescence and leaching - specific results will vary pending the type of spray that is applied.

It is recommended to clean the concrete surface prior to application. Any dirt, oil or foreign substances may hinder the effectiveness of the spray. After such a spray is applied, the surface should be flushed with water before drying.

The prevention of moisture and soil gases permeating through concrete surfaces goes a long way in reducing the growth of mold and eliminating the musty smell that often plagues a basement and/or crawl space. Waterproofing contractors have always been called to address immediate water problems for the short-term; with indoor air quality control, contractors can now offer a viable long-term service that provides their customers with the ultimate peace of mind.

finished crawl space

5 Helpful Tips For When it is Time to Encapsulate Your Crawl Space

Many homeowners try to cut costs and increase their home's comfort level by installing a crawl space vapor barrier. This will instantly make your home healthier for you and your family, and prevent moisture damage, mold, mildew, foul smells and odors.

Most homeowners tend to look at their crawl space as separate space from their home, but in reality, the two are one. Water vapors that surface from the ground are continuously entering, creating undesirable conditions for you, your family, and your home.

Purpose

The purpose of a crawl space vapor barrier is to stop moisture and wetness from entering and affecting the floor and walls of your basement. Moisture tends to flow from warmer to colder spaces.

Many homeowners don't realize the importance of the proper installation, in order to keep moisture and water vapors from getting in the walls and floor of your basement-- condensation can lead to expensive structural damage. Also, if you can help control the moisture and dampness, you can greatly reduce the amount of energy required to cool and heat your home.

Preparation

When considering the installation of a vapor barrier, take into consideration two spaces in your home; the crawl space and the attic. Humidity tends to build in the walls of both these areas causing mold, mildew and dry rot. This can cause severe health issues for adults and children, especially for those with asthma, breathing difficulties, and allergies. In addition, it can cause severe structural damage to your home.

Some homeowners think that because they insulate the floor joists there is no need to do any additional work, but these items do not serve the same purpose!

Tips for Installation

One of the most popular do-it-yourself vapor barrier products is polyethylene, or plastic sheeting. This plastic sheeting comes in various thicknesses; 4mm, 6mm and 10mm.

With today's technology, this product is made from a high quality material, resistant to rips and punctures. Always check the soil so there aren't any objects or materials that may damage the lining. The slightest puncture, rip or tear could compromise the entire system.

Always, make sure the space is dry before you begin any repairs. To remove the moisture, you may need a dehumidifier.

Overlap the barrier a minimum of 12 inches on the side walls. Be sure it is tight. Use furring strips and masonry nails to firmly secure the lining then caulk along the joints.

Seal all the seams with a heavy duty tape. However, it is recommended not to use tapes that are not specially designed for sealing vapor barriers. When working in the basement you will be forced to contend with pipes, make the proper cuts and seal securely with tape.

The completion of your crawl space vapor barrier will be the best investment you can make in your home.


Crawl Space Masters Specializes In Crawl Space Encapsulation in Falling Water TN.

http://crawlspacemasters.com/chattanooga/