crawl space repair Collierville, Tennessee

The crawl space has an integral role towards a home’s overall value as well as the living space above. Most homeowners in Collierville Tennessee  don’t think twice about their crawl space unless they have to make repairs to plumbing, heating ducts or house wiring. While often thought of as no more than a storage area, it also has a tremendous impact on the overall indoor air quality of the entire home.

crawl space drainage

The Best encapsulate crawl space cost In Collierville TN

By default, the air quality of a crawl space is typically poor. Mold, mildew, radon gas and poor energy efficiency all create several problems. The air that circulates within it eventually makes its way up through the living space. Scientific studies show that up to 50% of living space air originates from the lowest level of the home. With homeowners more concerned about their home’s indoor air quality, the encapsulating of crawl spaces has become a popular solution for such problems.

A damp crawl space creates a safe harbor for harmful molds, in addition to dust mites, termites and other bugs that can infest the home. The presence of excessive moisture will also create a serious problem with the probability for the wooden structure of a home to deteriorate. Crawl space vents pose a further problem. While believed to be a solution to moisture problems, they, unfortunately, make the problem worse. As it turns out, the vents allow cold air and moisture in, which rises into the living area and therefore decreases the heating efficiency of the entire home.

Another all-too-common problem associated with crawl spaces is radon gas. Though it cannot be seen, smelled or tasted, radon is a radioactive gas that can contribute to poor health, including cancer. Radon gas makes its way through the earth, into the crawl space and the home’s living space. According to the U.S.E.P.A., radon gas is the number one leading cause of lung cancer in non-smokers.

Ignoring these various conditions is not recommended for both long-term health and energy usage. Fully encapsulating a crawl space – by both sealing and insulating – is a fully efficient measure in addressing such problems. It makes sense to maintain and improve the lower level area in order to maximize healthy living conditions and home resale value.

While there are several systems for encapsulating, a zero perm liner system that also insulates and reflects heat provides the most benefits. With a proper floor and wall liner, the area will not only be well insulated but will seal out moisture, bug infestation, and radon gas. Other components to look for in a system include a radon gas-dispersing drain fabric, a radon gas ventilation pipe, and a ceiling heat shield.

A complete system with all of the above components will allow any soil gasses – including radon gas – that naturally occur under the liner system, to wick through the drain fabric and escape out through the ventilation pipe. While improved indoor air quality is the primary benefit of a sealed and insulated crawl space, the homeowner will also appreciate a bright, clean, and dry storage area; the ridding of musty smells; less energy usage; and tax credits. Contractors encapsulating crawl spaces will have more to offer to their clients when they can assure the peace of mind with improved indoor air quality.

cost to encapsulate crawl space

A Vapor Barrier in Your Crawlspace is a Healthy Addition For Your Family

A crawl space dig out is the process of turning your crawl space into a basement. This vastly increases storage space and can, in some cases, increase living space as well.

But, a crawl space dig out can be an enormous and daunting task. And, if done improperly, it can be dangerous. If you don't want to have a professional do it for you, please follow the steps below.

To get started, find place in the outside wall of your crawl space that you can safely enter the new basement with a temporary or permanent set of steps. Make sure the wall opening is big enough to handle at least a 36-inch door, preferably making the area for the steps at least 48-inches wide.

Warning:

If your soil is sandy or gravel and or may be full of water at least part of the year do not consider this procedure, it is very dangerous and you may damage or lose your house.

Make sure that prior to digging the hole for the outside exit, please build a header of sufficient size to hold the floor of the home where you will be removing the old foundation.

You need to excavate to a depth that will accommodate a four-inch concrete slab and still have at least 7-foot, 6-inches of clearance under your floor joist. It is entirely possible that you will have 48 inches of soil to remove.

When digging out a crawl space, you can not excavate any closer than 24 inches away from the existing foundation.

You can remove the soil sufficiently to work along the wall without removing the entire area you wish to change.

When you get the soil out to a depth that you prefer, pour a footer that is eight inches thick and 16 inches wide. The footer should be below the bottom of the new slab so it is a good idea to dig the area for the footer below the level you remove for the floor area. This is a very important step in a crawl space dig out.

Then, when your block is level with bottom of the old foundation wall you need to pour a four-inch thick slab of concrete on top of the wall and over to the outside existing wall.

Prior to pouring your "Cap" you must fill between the block and soil that is under the old foundation with fill sand or "Pea-gravel." Assuming that you probably have some kind of support under the center section of the floor system, you will have to provide support for the beam that is presently supporting the floor while excavate for a new footer for a steel post that will hold the floor of your new space.

Make sure your footer for this part of the project is about eight inches thick & 24 inches square.

You will need to level the floor area for your new slab and install four inches of perforated plastic pipe draining to a sub pit with an automatic sub pump that dispenses the water to the outside at least five to ten feet away from the foundation of the home. I'd suggest using "Pea-gravel" for fill under the slab but you can you fill sand also.

Now, build your stairs to the outside in a similar fashion but you need to cover it with a steel "pre-fab" unit such as a "BILCO."

If you do this correctly and maintain it, it will last for many, many years. It is strongly suggested you get a professional to do this job or at least help with it because mistakes can be dangerous and very costly.

finished crawl space

The Three Basic Types of Home Foundations

Crawl space is one of the most fundamental areas in every home which needs to be kept extremely clean. This is the reason why people go for crawl space encapsulation kits, as these liners make your crawl space extremely clean by keeping away insects, water logging and bad odor. However, the market displays numerous encapsulation kits in different qualities.

Good quality encapsulation kits are more expensive than the cheaper ones, but the cheaper ones are much weaker when it comes to quality. Unfortunately, in my extensive experience in this industry, I have noticed that people are attracted to cheaper ones and choose them for their encapsulation. However, they regret later when the whole thing fails to deliver what it promises.

This undoubtedly is the reason why I suggest using DIY encapsulation kits to save a considerable amount of money. How? It is not only the DIY kit that is expensive, but what's more expensive are the labor charges that come along with it. Labor charges have been increasing higher than ever, and this is the reason why it costs you as much as the encapsulation kits itself. However, if you opt for using DIY encapsulation kit you can save a considerable amount of money that you might spend on labor charges.

Moreover, you can also do your encapsulation at the convenience of your time, patience and energy. You do not have to wait for the professional to arrive at your home, analyze your crawl space and then start the job. Sometimes, this may take longer than you even expect it to finish. This undisputedly becomes the reason why people are more open to taking up DIY kit, as this can finish up their crawl space encapsulation as fast as possible.

What's more? Choosing a DIY kit will help you to ascertain the quality of your liner and the credibility it comes with when protecting your home. By choosing this kit you can take your time and choose the one that suits your preferences and is a permanent solution to your problems. If you leave this to the dealer, you cannot be sure on the quality of liners they will be using and the credibility of their service.

By doing the encapsulation yourself you can be sure that you have done it perfectly and can also alter some changes according to your preference. Hiring a professional will not only take your time and money, but may not be as flexible as you may think.

Crawl space DIY kits are readily available in the market and all you need to do is to research a bit on the types available. Remember, to choose a good quality liner because it all depends on the quality of the liner when it comes to completing the protection of your house.


Crawl Space Masters Specializes In Crawl Space Encapsulation in Collierville TN.

http://crawlspacemasters.com/tennessee/