The crawl space has an integral role towards a home’s overall value as well as the living space above. Most homeowners in Northside Chattanooga don’t think twice about their crawl space unless they have to make repairs to plumbing, heating ducts or house wiring. While often thought of as no more than a storage area, it also has a tremendous impact on the overall indoor air quality of the entire home.
The Best Clean Crawl Space In Northside TN
By default, the air quality of a crawl space is typically poor. Mold, mildew, radon gas and poor energy efficiency all create several problems. The air that circulates within it eventually makes its way up through the living space. Scientific studies show that up to 50% of living space air originates from the lowest level of the home. With homeowners more concerned about their home’s indoor air quality, the encapsulating of crawl spaces has become a popular solution for such problems.
A damp crawl space creates a safe harbor for harmful molds, in addition to dust mites, termites and other bugs that can infest the home. The presence of excessive moisture will also create a serious problem with the probability for the wooden structure of a home to deteriorate. Crawl space vents pose a further problem. While believed to be a solution to moisture problems, they, unfortunately, make the problem worse. As it turns out, the vents allow cold air and moisture in, which rises into the living area and therefore decreases the heating efficiency of the entire home.
Another all-too-common problem associated with crawl spaces is radon gas. Though it cannot be seen, smelled or tasted, radon is a radioactive gas that can contribute to poor health, including cancer. Radon gas makes its way through the earth, into the crawl space and the home’s living space. According to the U.S.E.P.A., radon gas is the number one leading cause of lung cancer in non-smokers.
Ignoring these various conditions is not recommended for both long-term health and energy usage. Fully encapsulating a crawl space – by both sealing and insulating – is a fully efficient measure in addressing such problems. It makes sense to maintain and improve the lower level area in order to maximize healthy living conditions and home resale value.
While there are several systems for encapsulating, a zero perm liner system that also insulates and reflects heat provides the most benefits. With a proper floor and wall liner, the area will not only be well insulated but will seal out moisture, bug infestation, and radon gas. Other components to look for in a system include a radon gas-dispersing drain fabric, a radon gas ventilation pipe, and a ceiling heat shield.
A complete system with all of the above components will allow any soil gasses – including radon gas – that naturally occur under the liner system, to wick through the drain fabric and escape out through the ventilation pipe. While improved indoor air quality is the primary benefit of a sealed and insulated crawl space, the homeowner will also appreciate a bright, clean, and dry storage area; the ridding of musty smells; less energy usage; and tax credits. Contractors encapsulating crawl spaces will have more to offer to their clients when they can assure the peace of mind with improved indoor air quality.
The Three Basic Types of Home Foundations
A crawl space dig out is the process of turning your crawl space into a basement. This vastly increases storage space and can, in some cases, increase living space as well.
But, a crawl space dig out can be an enormous and daunting task. And, if done improperly, it can be dangerous. If you don't want to have a professional do it for you, please follow the steps below.
To get started, find place in the outside wall of your crawl space that you can safely enter the new basement with a temporary or permanent set of steps. Make sure the wall opening is big enough to handle at least a 36-inch door, preferably making the area for the steps at least 48-inches wide.
If your soil is sandy or gravel and or may be full of water at least part of the year do not consider this procedure, it is very dangerous and you may damage or lose your house.
Make sure that prior to digging the hole for the outside exit, please build a header of sufficient size to hold the floor of the home where you will be removing the old foundation.
You need to excavate to a depth that will accommodate a four-inch concrete slab and still have at least 7-foot, 6-inches of clearance under your floor joist. It is entirely possible that you will have 48 inches of soil to remove.
When digging out a crawl space, you can not excavate any closer than 24 inches away from the existing foundation.
You can remove the soil sufficiently to work along the wall without removing the entire area you wish to change.
When you get the soil out to a depth that you prefer, pour a footer that is eight inches thick and 16 inches wide. The footer should be below the bottom of the new slab so it is a good idea to dig the area for the footer below the level you remove for the floor area. This is a very important step in a crawl space dig out.
Then, when your block is level with bottom of the old foundation wall you need to pour a four-inch thick slab of concrete on top of the wall and over to the outside existing wall.
Prior to pouring your "Cap" you must fill between the block and soil that is under the old foundation with fill sand or "Pea-gravel." Assuming that you probably have some kind of support under the center section of the floor system, you will have to provide support for the beam that is presently supporting the floor while excavate for a new footer for a steel post that will hold the floor of your new space.
Make sure your footer for this part of the project is about eight inches thick & 24 inches square.
You will need to level the floor area for your new slab and install four inches of perforated plastic pipe draining to a sub pit with an automatic sub pump that dispenses the water to the outside at least five to ten feet away from the foundation of the home. I'd suggest using "Pea-gravel" for fill under the slab but you can you fill sand also.
Now, build your stairs to the outside in a similar fashion but you need to cover it with a steel "pre-fab" unit such as a "BILCO."
If you do this correctly and maintain it, it will last for many, many years. It is strongly suggested you get a professional to do this job or at least help with it because mistakes can be dangerous and very costly.
Crawl Space Repair Without a Fan or Vent
When a home has sagging floors, the signs many be obvious, or they may be quite subtle. Here are some questions a home owner can ask himself to glean whether or not sagging floors is a real problem for his home.
- Does it seem that the home's floors sag towards the middle of the room?
- Does furniture slide away from walls and creep towards the middle of the room?
- Are there gaps in between the home's floor and baseboards?
- Do the home's cabinets rattle when someone walks through a room?
Many homeowners ask what causes sagging floors. Sagging floors can be caused by several factors:
- A shifting foundation beneath the home
- Floor joists in the home that have been weakened by excessive moisture
- Excessively large of spans between floor joists without enough support
- Excessive or heavy loads (furniture, gym equipment, granite) in the room(s) above a home's crawl space
- The use of temporary shims to fill flooring gaps; shims settle and shift out of place over time
The solution is more simple than it might seem! Adjustable steel crawl space supports are an economical and quick solution that can withstand the test of time. These adjustable posts are a permanent solution that work by transferring the weight of the home's flooring structure to more competent soils beneath the home. Many homeowners will attempt a do-it-yourself solution for sagging floors by inserting wooden shims to prop the floor back up. This is only a temporary band-aid and does not address the fundamental issues with the flooring structure. Shims made from wood, which are often a homeowner's first solution for the repair, can slip, shift and rot over time.
By contrast, the adjustable steel supports can be installed quickly (in less than one day), with little to no disturbance done to the property. Also, they are able to provide adequate support exactly where it is needed most. As the name implies, the supports can be adjusted in order to provide the exact amount of support needed, and they are fully compatible with a crawl space encapsulation system, should a home need that as well.
Crawl space repair is a common procedure done in many homes all over America. Unfortunately, many homeowners are unknowingly choosing temporary and insufficient means to support their homes, thinking that the professional and permanent solution will be too costly, disruptive, and time consuming. Adjustable steel crawl space supports can fix a home's sagging floors permanently without disrupting the family, the yard, or the wallet too much!
Crawl Space Masters Specializes In Crawl Space Encapsulation in Northside TN.