The crawl space has an integral role towards a home’s overall value as well as the living space above. Most homeowners in Hardin Valley Knoxville don’t think twice about their crawl space unless they have to make repairs to plumbing, heating ducts or house wiring. While often thought of as no more than a storage area, it also has a tremendous impact on the overall indoor air quality of the entire home.
The Best Crawl Space Repair In Hardin Valley TN
By default, the air quality of a crawl space is typically poor. Mold, mildew, radon gas and poor energy efficiency all create several problems. The air that circulates within it eventually makes its way up through the living space. Scientific studies show that up to 50% of living space air originates from the lowest level of the home. With homeowners more concerned about their home’s indoor air quality, the encapsulating of crawl spaces has become a popular solution for such problems.
A damp crawl space creates a safe harbor for harmful molds, in addition to dust mites, termites and other bugs that can infest the home. The presence of excessive moisture will also create a serious problem with the probability for the wooden structure of a home to deteriorate. Crawl space vents pose a further problem. While believed to be a solution to moisture problems, they, unfortunately, make the problem worse. As it turns out, the vents allow cold air and moisture in, which rises into the living area and therefore decreases the heating efficiency of the entire home.
Another all-too-common problem associated with crawl spaces is radon gas. Though it cannot be seen, smelled or tasted, radon is a radioactive gas that can contribute to poor health, including cancer. Radon gas makes its way through the earth, into the crawl space and the home’s living space. According to the U.S.E.P.A., radon gas is the number one leading cause of lung cancer in non-smokers.
Ignoring these various conditions is not recommended for both long-term health and energy usage. Fully encapsulating a crawl space – by both sealing and insulating – is a fully efficient measure in addressing such problems. It makes sense to maintain and improve the lower level area in order to maximize healthy living conditions and home resale value.
While there are several systems for encapsulating, a zero perm liner system that also insulates and reflects heat provides the most benefits. With a proper floor and wall liner, the area will not only be well insulated but will seal out moisture, bug infestation, and radon gas. Other components to look for in a system include a radon gas-dispersing drain fabric, a radon gas ventilation pipe, and a ceiling heat shield.
A complete system with all of the above components will allow any soil gasses – including radon gas – that naturally occur under the liner system, to wick through the drain fabric and escape out through the ventilation pipe. While improved indoor air quality is the primary benefit of a sealed and insulated crawl space, the homeowner will also appreciate a bright, clean, and dry storage area; the ridding of musty smells; less energy usage; and tax credits. Contractors encapsulating crawl spaces will have more to offer to their clients when they can assure the peace of mind with improved indoor air quality.
Crawl Space Vapor Barrier - A Beginner's Guide On Buying The Right One
A crawl space dig out is the process of turning your crawl space into a basement. This vastly increases storage space and can, in some cases, increase living space as well.
But, a crawl space dig out can be an enormous and daunting task. And, if done improperly, it can be dangerous. If you don't want to have a professional do it for you, please follow the steps below.
To get started, find place in the outside wall of your crawl space that you can safely enter the new basement with a temporary or permanent set of steps. Make sure the wall opening is big enough to handle at least a 36-inch door, preferably making the area for the steps at least 48-inches wide.
If your soil is sandy or gravel and or may be full of water at least part of the year do not consider this procedure, it is very dangerous and you may damage or lose your house.
Make sure that prior to digging the hole for the outside exit, please build a header of sufficient size to hold the floor of the home where you will be removing the old foundation.
You need to excavate to a depth that will accommodate a four-inch concrete slab and still have at least 7-foot, 6-inches of clearance under your floor joist. It is entirely possible that you will have 48 inches of soil to remove.
When digging out a crawl space, you can not excavate any closer than 24 inches away from the existing foundation.
You can remove the soil sufficiently to work along the wall without removing the entire area you wish to change.
When you get the soil out to a depth that you prefer, pour a footer that is eight inches thick and 16 inches wide. The footer should be below the bottom of the new slab so it is a good idea to dig the area for the footer below the level you remove for the floor area. This is a very important step in a crawl space dig out.
Then, when your block is level with bottom of the old foundation wall you need to pour a four-inch thick slab of concrete on top of the wall and over to the outside existing wall.
Prior to pouring your "Cap" you must fill between the block and soil that is under the old foundation with fill sand or "Pea-gravel." Assuming that you probably have some kind of support under the center section of the floor system, you will have to provide support for the beam that is presently supporting the floor while excavate for a new footer for a steel post that will hold the floor of your new space.
Make sure your footer for this part of the project is about eight inches thick & 24 inches square.
You will need to level the floor area for your new slab and install four inches of perforated plastic pipe draining to a sub pit with an automatic sub pump that dispenses the water to the outside at least five to ten feet away from the foundation of the home. I'd suggest using "Pea-gravel" for fill under the slab but you can you fill sand also.
Now, build your stairs to the outside in a similar fashion but you need to cover it with a steel "pre-fab" unit such as a "BILCO."
If you do this correctly and maintain it, it will last for many, many years. It is strongly suggested you get a professional to do this job or at least help with it because mistakes can be dangerous and very costly.
Thinking Long-Term Safety & Health With Proper Foundation Structural Repair & Basement Waterproofing
In recent years, the idea of indoor air quality control has become a bigger concern to the basement waterproofing industry. When I began working with the industry over 20 years ago, the idea of basement waterproofing was exclusive to the controlling of and prevention of water seepage and flooding. With homeowners becoming more aware of radon gas infiltration, moisture and mildew, and other soil gases, waterproofers have the perfect opportunity to better serve their customers by addressing such needs.
Musty smells, moisture and radon gas - all common problems in a basement and/or crawl space, are solvable by enacting some of the most basic waterproofing techniques. Improving indoor air quality, beginning from the basement and/or crawl space will impact the air quality of the entire home. Over 50 percent of the air that circulates through the home's living space originates from the basement and or crawl space. When the air quality of the basement or crawl space is poor, chances are, the entire home's air quality is poor or soon will be.
One of the first measures a contractor can do to address such concerns is by applying a sodium based silicate spray onto the basement's walls and floors. Such a spray typically reacts with the concrete's free lime, resulting in the formation of an expanded crystalline structure beneath the surface. The application of a deep-penetrating concrete sealer stops water vapor and radon gas from permeating the porous surfaces. This allows the concrete to become dense, increasing its resistance to various vapors and gases. Such sealants usually can be applied with a low-pressure hand sprayer.
When applying the right sodium based silicate spray, some of the additional advantages may include the reduction of spalling from freeze and thaw cycles; improving a concrete structure's resistance to most soils, acids, oils and salts; and protecting against efflorescence and leaching - specific results will vary pending the type of spray that is applied.
It is recommended to clean the concrete surface prior to application. Any dirt, oil or foreign substances may hinder the effectiveness of the spray. After such a spray is applied, the surface should be flushed with water before drying.
The prevention of moisture and soil gases permeating through concrete surfaces goes a long way in reducing the growth of mold and eliminating the musty smell that often plagues a basement and/or crawl space. Waterproofing contractors have always been called to address immediate water problems for the short-term; with indoor air quality control, contractors can now offer a viable long-term service that provides their customers with the ultimate peace of mind.
Crawl Space Masters Specializes In Crawl Space Encapsulation in Hardin Valley TN.